question about some thoughts about doing mods.

[rookerrobert]

I'm goig to put 1050x injectors,thermal blanket with spacers,180 thermo. and litens 2.85 pulley. The question or should say opinion's is this.....to get the factory pulley off the snout I have read several post about the problems getting them loose.Most seem to use an impact tool but my thought are if you put the tool into the pulley and instead of a impact wrench just tka e box end wrench and tack a hammer and strike the wrench that sudden hit should break it loose?

 

[Speedy!]

It's the rapid taps from the impact that get the job done easily in most cases.

 

[rookerrobert]

yep thats the reason I think a good lick on a boxed in will do the same....I know during holidays I'm gonna find out....lol who know it may come use without and problem's..I call my method redneck tech!!!!

 

[rookerrobert]

it read on the instruction's not to use impact didnt say a darn thing about boxed wrench and hammer

 

[jonx96]

it read on the instruction's not to use impact didnt say a darn thing about boxed wrench and hammer

It prolly meant no to use for install

 

[rookerrobert]

no the install should be easy your turning it clock wise....I'm just gonna like speedy to about 70 ft.lbs. I'm kinda going to get an idea what the mods, will do.The last time at the track it ran 10.83@127, 10.89@127 and it's stock but with mods I'll see what kind of difference a 2.85 pulley,180 thermo and spacer plates and also a tune for sure.